Elektrine lite

← Feed

@halfpress@mastodon.halfpress.com

2026-08-02 01:35 UTC

Noticing that the cross bar feet on the machine - aside from having those horrible abrasive rusted pads pictured earlier - have cracked over time with age. Oddly, the cracks are only on one side of the piece and fine on the other. I’ll see what I can do to improve them, but these might be candidates for modeling and 3D printing as replacements.

Replies (1)

  • Bit of a temporary hack, but I donut-holed some thick, dense adhesive furniture foot pads to keep the rusty bits from making surface contact. I tried prying those rusty pads out, but no go without damaging the plastic foot itself.

    Open ##5053173