2026-10-28 12:05 UTC
A fun difference in modern day and old pins is how their flippers are controlled. Back in the old days they had 2 power settings; full power for the flip and a weaker to hold the flipper up. This was mechanically controlled by the end of stroke switch, that physically cut the power to the high power side of the flipper coil after the flipper had travelled far enough.
This switch had two typical failure modes: if the switch got stuck open, it would flip with the hold power, basically rendering it useless. If again it got stuck closed, it would hold with flip power and result in burnt coil smell.
Computer controlled flippers, such as in this 2021 Godzilla do the power setting change in software, but use the switch to determine the spot where the power change happens. They also note if the switch is broken and instead use pure timing. This compensation works so well the players don't necessarily even notice it, which is what had happened here. The only thing they lose is the flipper momentarily using the high power setting should a fast moving ball press the flipper down.
#pinball #repair #retrotech
Replies (0)
No replies.