Elektrine lite

← Feed

@drawks@hachyderm.io

2025-06-09 00:45 UTC

@mimblewimble yeah, that's the idea. I sort fed the CA glue into the cracks and let it wick into the delaminated sections while clamping some delams that ran all the way to the edge. Allow it to cure then used files and aggressive abrasive to debulk any high spots and open up any bubbles then repeat the glueing again until everything had a contiguous surface without any cracks that were opening up when gently flexing the part. Then a lot of "prep" sanding to a generally uniform surface with almost no epoxy/glue thickness above the weave. From there it is basically a paint job with 2k clear starting with a tack coat and then about 4 wet coats with ample flash time between. Left the clear to cure for a couple of days in a warm dry place and then lots of wet sanding, buffing and polishing; while being very careful to avoid burning through the clear. Lots of compound curves means that most of the sanding had to be done by hand so I could keep even pressure.

Replies (0)

No replies.