2026-07-11 11:23 UTC
@dcz@fosstodon.org i don't find printing a piece of paper and ironing it too bothersome. even compared to loading a filament alone, not even speaking of attaching the cuprexit to the bed and setting the z offset.
but perhaps there are some good tricks i could learn, which is why i'm curious about how you did it. because the result looks stunning!
i've tried doing .2mm traces and basically failed. i do .5mm minimum.
Replies (1)
-
@dcz@fosstodon.org 2026-07-11 11:30
@lkundrak@metalhead.club Oh, it's cool to know how my results compare to others. I learned to do 0.3mm traces by default. It is already kinda risky because when my method works, it works great, but half of the time one part of the board etches much faster than another and those 0.3mm traces get eaten before others separate properly. I still need to get a good feeling for when this happens. One thing I know is that fresh solutions help.