@punishmenthurts@autistics.life
2026-08-04 00:39 UTC
OK, so, I’ve turned it around.
.
It’s a pity the sloppy string spread at the nut, otherwise the Martin’s nut fits perfectly, except I missed on the spread and not in a repairable way, you can’t fill those slots for the A strings and cut away all that’s left of the original. I’m still going to get it set up proper.
.
These strings are finally done, stretched and some broken and sounding it - but according to fedex, the tuners are coming tomorrow.
.
Still a thing or two, there’s the extra two inlay dots to come out, and with the action better I can see a little body rise, I need to take the highest frets down, above #15.
.
Then the new tuners and strings. Then when it settles into tune again and I play the sheen off the new strings, we’ll see what we got. 💜🎶🎸
.
/58
#Luthier #Guitar #Framus12StringProject
Replies (2)
-
@punishmenthurts@autistics.life 2026-08-04 01:25
Hey look, when the bass strings are on the bass side, the inlay dots don’t look so bad! Ha. 😜 . /59 #Luthier #Guitar #Framus12StringProject
-
@GuitarSith@fosstodon.org 2026-08-04 01:37
@punishmenthurts@autistics.life When I did the reversal on my 12 string I actually ended up making a new nut. It was just too difficult to try and modify the existing one and the reversed strings just don't sit properly in the original. Found the same for the plastic portion of the bridge, had to replace it with a new piece with the grooves set properly for the reversed string thicknesses.