Elektrine lite

← Feed

@jpm@aus.social

2026-09-01 00:40 UTC

@timixretroplays@digipres.club oh yeah, cheap tap and die set makes 3D printed threads actually work well. Slightly expand/shrink the thread so the tap or die can bite in and remove a bit of material for a super-clean finish.

Replies (1)

  • @jpm@aus.social it's interesting how this feels vs just scaling the inner threads inwards by a tiny amount. This really does feel like two metal parts going together, complete with the clearances that allow them to wobble slightly while the first few rounds of thread engage. There's practically no resistance until it's tightened against the threads that are too low to cut (or bottoming out in the lid), at which point it becomes satisfyingly snug.

    Open ##5173227