Elektrine lite

← Feed

@penguin86@social.ichibi.eu

2026-07-30 21:01 UTC

@Gaziel@mastodon.social I used Kicad to route the circuit, then "plotted" to an SVG and opened in Inkscape. There, I used the plugin "gcodetools" (is already present by default on a clean install) to generate the gcode. Then I added a pause in the gcode just after the first penetration to tape the pen to the printer. On the printer, I start the print, tape the pen and set the z-height so the pen just touches the pcb. I do 3 passes increasing the height of 0.05mm every time to deposit a new layer of ink without scraping away the one from the previous pass. Then I engrave it in the ferric chloride.

Replies (0)

No replies.