Elektrine lite

← Feed

@timixretroplays@digipres.club

2026-08-31 09:23 UTC

Revisited this idea today and topped off the cube-jar with an M12-1.75 thread, modeled with #BoltGen in #Rhino3D and then physically cut into the correct geometry using the M12 die from my cheap metric tap-and-die set. That seems to have worked, so next up is a matching lid with a thread to be cut with the same kit. This was also printed with random seam placement and scarf joint seams - that seems to work well these days, leaving an interesting but not undesirable texture. #3DPrinting

Replies (2)

  • That's... worked? #3DPrinting metric threads, then cutting them with a cheap tap-and-die set appears to work just fine for making entirely printed parts that just screw together. Lining them up is a tiny bit awkward - I think a conical cutout on both sides will help register the parts together - but otherwise this has pretty much exceeded my expectations entirely.

    Open ##5173217

  • @aeberbach@mastodon.online 2026-08-31 14:23

    @timixretroplays@digipres.club theoretically it is possible to print a thread but even the ones at finest resolution benefit from cleaning up with tap or die.

    Open ##5173233