Elektrine lite

← Feed

@timixretroplays@digipres.club

2026-08-31 09:47 UTC

That's... worked? #3DPrinting metric threads, then cutting them with a cheap tap-and-die set appears to work just fine for making entirely printed parts that just screw together. Lining them up is a tiny bit awkward - I think a conical cutout on both sides will help register the parts together - but otherwise this has pretty much exceeded my expectations entirely.

Replies (2)

  • @Siff@mstdn.social 2026-08-31 12:09

    @timixretroplays@digipres.club Nice! šŸ‘ I’m using 3D printed threads for quite some time (one of my first prints were a bolt and a nut) and they work quite well when printed in PLA. I only had issues with small (< M5) bolts and nuts when printed in PETG since they tend to bite into each other, but work well when cleaned with tap and die or shrunk/expanded by 1% in the slicer. Also, yes, a chamfer helps a lot. šŸ™‚ (I chamfer or put filets on every edge - a habit from when I learned how to work on a lathe).

    Open ##5173219

  • @jpm@aus.social 2026-09-01 00:40

    @timixretroplays@digipres.club oh yeah, cheap tap and die set makes 3D printed threads actually work well. Slightly expand/shrink the thread so the tap or die can bite in and remove a bit of material for a super-clean finish.

    Open ##5173223