Elektrine lite

← Feed

@dcz@fosstodon.org

2026-07-11 11:02 UTC

@lkundrak@metalhead.club I can take more on Monday :) I don't think I would have bothered with toner transfer. With the 3D printer, several steps collapse into one. Plug in the USB stick with the design, new board in, 4 minutes wait, straight into developer solution.

Replies (1)

  • @lkundrak@metalhead.club 2026-07-11 11:23

    @dcz@fosstodon.org i don't find printing a piece of paper and ironing it too bothersome. even compared to loading a filament alone, not even speaking of attaching the cuprexit to the bed and setting the z offset. but perhaps there are some good tricks i could learn, which is why i'm curious about how you did it. because the result looks stunning! i've tried doing .2mm traces and basically failed. i do .5mm minimum.

    Open ##5205821